We have extensive resources on this subject. Below are general works on laboratory and field testing. In addition to these we have special pages with the following:
Jim Sheahan, P.E., Aaron Zdinak, P.E., and Jerry DiMaggio, P.E.
This document presents information intended to assist users with effectively incorporating Quality Assurance (QA) into the preparation of Geotechnical Reporting Documents (GRDs), which includes reports and other documents that communicate geotechnical data, analysis and recommendations. This document draws extensively from Department of Transportation (DOT) experience across the United States. Interviews from several state DOTs were used as a basis for developing QA guidance and applying it to alternative contracting methods (ACM). This manual discusses the distinction between Quality Control (QC) and QA, and guidance is provided on the interactive process they play in the development of GRDs. The use of checklists and QA documentation is discussed in this document, and FHWA-ED-88-053 is referenced as a basis for developing agency/owner specific checklists.
U.S. Department of Interior, Bureau of Reclamation
Part I, Third Edition
The manual provides current technical information on the field and laboratory investigations and construction control of soils used as foundations and materials for dams, canals, and many other types of structures built for Reclamation projects in the United States of America. It contains both standardized procedures that have been found desirable for securing uniform results throughout the Bureau, and general guidelines intended to assist but not to substitute for engineering judgement.
- Chapter I describes the Unified Soil Classification System developed jointly by the Bureau of Reclamation and the Corps of Engineers, Department of the Army, from the system proposed by Professor A. Casagrande of Harvard University, and discusses the various properties of soils relating to engineering uses.
- Investigations of soils are covered in chapter II which describes the various stages of investigation corresponding to the stages of development of the Bureau projects, and gives technical information necessary for planning and executing explorations and for presenting the results.
- Chapter III presents information on the control of construction from the soils standpoint, for both foundation treatment and compaction control of fills. In addition to a general treatment of the subject applicable to all types of earthwork, separate sections are devoted to problems of rolled earth dams, canals, and miscellaneous construction features. For each of these, information on design features and usual specifications provisions are given to provide control personnel with a background to assist in implementing the recommended control techniques.
The appendix contains detailed procedures for sampling, classification, and field and laboratory testing of soils. Instructions for installing and obtaining information from instruments that measure pore-water pressures and displacements within and adjacent to earth embankments are also included. A tabulation of conversion factors commonly used in earth construction is included at the end of the appendix.
USACOE EM 1110-1-1084
1 January 2001
- EM 1110-1-1804, Geotechnical Investigations, 29 February 1984
- EM 1110-1-1906, Soil Sampling, 30 September 1996 (this manual includes a copy of that one)
This manual establishes criteria and presents guidance for geotechnical investigations during the various stages of development for civil and military projects. The manual is intended to be a guide for planning and conducting geotechnical investigations and not a textbook on engineering geology and soils exploration. Actual investigations, in all instances, must be tailored to the individual projects.
Geotechnical investigations are performed to evaluate those geologic, seismologic, and soils conditions that affect the safety, cost effectiveness, design, and execution of a proposed engineering project. Insufficient geotechnical investigations, faulty interpretation of results, or failure to portray results in a clearly understandable manner may contribute to inappropriate designs, delays in construction schedules, costly construction modifications, use of substandard borrow material, environmental damage to the site, post-construction remedial work, and even failure of a structure and subsequent litigation. Investigations performed to determine the geologic setting of the project include: the geologic, seismologic, and soil conditions that influence selection of the project site; the characteristics of the foundation soils and rocks; geotechnical conditions which influence project safety, design, and construction; critical geomorphic processes; and sources of construction materials.
J. Erik Loehr, Ph.D., P.E., Alan Lutenegger, Ph.D., P.E., Brent Rosenblad, Ph.D., P.E., and Andrew Boeckmann, P.E.
We also feature this document’s predecessor, Evaluation of Soil and Rock Properties, FHWA-IF-02-034, April 2002
Characterization of subsurface conditions is one of the most challenging yet important activities required for successful planning, design, construction, and operation of transportation infrastructure. This manual is intended to provide a technical resource for geotechnical and highway engineers responsible for planning and performing subsurface investigations so that project subsurface conditions can be characterized effectively and risks attributed to ground conditions can be identified and addressed. The manual is organized to reflect the strong emphasis on interpretation of geotechnical parameters for design and construction. It describes important considerations for planning and scoping of geotechnical investigations; means and methods for classification of soil and rock based on index property measurements; identifying and characterizing potentially problematic soil and rock types for design and construction; guidance for interpretation of soil and rock properties from field and laboratory measurements; interpretation of geotechnical design parameters from collections of individual measurements; identification and characterization of geotechnical hazards; and lastly, guidance for documenting and reporting results from geotechnical investigations.
Soil Conservation Service
A training module for the Unified System of soil classification. Includes several lessons and an extensive glossary.